How To Get Ink Out Of Carpet isn’t an easy task, and the longer you wait to clean it up, the more difficult it will be to remove the stain. When you spill ink onto your carpet, you should remove it right away to prevent it from sinking in, getting worse, potentially damaging your carpet, and leaving a lasting stain. Here are some tips on how to best get ink out of the carpet.
What’s the Best Way to Get Ink Out of Carpet?
Blot up as much as you can
Even if you don’t know how ink got on your carpet, it can still be relatively easy to get out as long as you act quickly. The longer an ink stain sits on a carpet, the harder it will be for cleaning solutions or laundry detergent to remove it completely. And even if you know exactly what caused an ink spill on your carpet, it’s always good practice to take immediate action. If you let a spilled pen sit for too long and then attempt to clean up with soap and water, soap scum and excess dirt will cling on top of any remaining stain. When that happens, manual scrubbing won’t be enough your only option will be shampooing or professional cleaning services. So blot up as much as possible!
Use an Absorbent Powder
To safely remove ink from the carpet, start by laying down a layer of an absorbent powder, like flour or baking soda. Allow that layer to dry completely before adding another coat, if necessary. In most cases, you can simply wait overnight for a thick enough layer that will effectively draw out ink and pigments when scraped away. If there’s still visible residue after one coat, add another. Be sure to wear gloves and avoid inhaling any dust as these powders can irritate your lungs.
Read Also: How To Get Blood Out Of Carpet
Follow Up With Water
When you have ink on your clothes, paper, or carpeting, you can use water and rubbing alcohol to loosen it. Using a clean white cloth, blot up as much ink as possible. Then dampen another clean white cloth with water and rub it into the stain until most of it disappears. Finish by dabbing some rubbing alcohol onto a fresh white cloth, wringing out any excess liquid, and dabbing at the remaining stain until gone. Note: Use only cold water; hot water could set in place stains that are already there or cause them to reappear after drying.
Rinse with Cold Water
First and foremost, don’t try to rub it out. This will only smear it around and make matters worse. Instead, run some cold water on it and then blot up as much liquid as you can with a paper towel or rag. Then use a dabbing motion similar to how you would apply conditioner and take another clean paper towel or rag and soak up as much excess ink from your carpeting as possible. You mustn’t use heat (blow dryer, steamer) because heat makes ink set quickly, which makes for a permanent stain that can be harder to remove. I found running ice cubes over my carpet worked well!
Clean The Area With A Mild Soap
Soap and water are a cheap, easy way to clean up almost any type of ink stain. Use plain tap water in place of an expensive cleaning product if you’re on a budget. Carefully dab at it with a sponge or paper towel too much scrubbing can make matters worse! Allow your soapy water mixture to sit for several minutes, then blot up as much as possible using paper towels. Larger stains may need treatment more than once; just make sure not to saturate carpet fibers further with excessive moisture. Once removed, follow up by vacuuming thoroughly. Be sure not to use too much heat when drying: High temperatures can permanently set the ink into carpet fibers!
Read Also: How to Get Nail Polish Out of Carpet
Use Cold Water To Rinse
The first step in cleaning ink out of the carpet is to remove as much of it as possible. Before you take any action, blot up excess ink from your carpet with a clean towel. The best way to deal with ink stains is by flooding them with cold water and letting them soak for five minutes or so. That’ll loosen most of it up before you begin pre-treating with an enzyme cleaner (we like Nature Clean Spot and Stain Remover). And then blot that up too. Just make sure you don’t saturate your carpet; water can act as a temporary solvent, but won’t dissolve all types of permanent marker ink.
Use Salt or Baking Soda
Baking soda is often a great carpet stain remover, especially if you’re dealing with an oily stain. Sprinkle baking soda directly on top of any stains and let it sit for about 15 minutes. Then, lightly rub over it with a clean cloth before vacuuming. Be sure to test in an inconspicuous area first! For tough oil-based stains that have soaked into your carpet, try making a paste out of salt and vinegar (1 cup salt + 1 cup vinegar). Leave it on for 5 minutes before cleaning off with a brush or broom; you can then follow up by vacuuming or cleaning with water (dampening it might cause water damage). Always test on an area that is not visible first.